HP Chromebook 11


This page contains information about the HP Chromebook 11 that is interesting and/or useful to software developers. For general information about getting started with developing on Chromium OS (the open-source version of the software on the Chrome Notebook), see the Chromium OS Developer Guide.

Note: there have been multiple devices released under the moniker "HP Chromebook 11". This page covers the first ARM boards. 


  • CPU: Samsung Exynos 5 Dual Core (Cortex A15; 1.7GHz cpu)
  • GPU: ARM Mali-T604 (Quad Core)
    • 1366x768 IPS screen with 300 nits (spring board)
    • 1366x768 TN panel (skate board)
  • RAM: 2 GiB DDR3
    • The memory is not upgradable as it is soldered directly to the board
  • Disk: 16 GiB SSD (connected to eMMC)
    • USB expansion ports
    • No SD slot
  • WiFi: 802.11 a/b/g/n
    • USB ports can handle Ethernet dongle
  • Power supply: 5.25V (DC) 3.A micro USB
  • No Kensington Security Slot
  • Servo header: Standard 2x25 / AXK750347G

The first release was the "spring" board. A later revision was named "skate" with a slightly different BOM.

Developer Mode

Caution: Modifications you make to the system are not supported by Google, may cause hardware, software or security issues and may void warranty.

Details for working with developer mode can be found on this page.


This device uses Das U-Boot to boot the system. You can find the source in the ChromiumOS u-boot git tree in the firmware-spring-3824.B branch.

There is also firmware in a custom embedded controller (which handles things like the keyboard), but we won't cover that here as you generally should not need to modify that. You can find the source in the ChromiumOS ec git tree (in the spring firmware branch).



Opening the case might void your warranty. It is also not recommended, since opening the case lifts the heat sink off the CPU and upon closing the case the thermal resistance might not fully recover. Especially, it is not recommended to run the device with the case opened.

But if you must open the case: Remove 11 screws (two of them hidden under the round rubber feet close to the hinge) and then crack open the case at the seam, starting on the edge close to the touchpad.